-
$285.00
OXFORD MICROANALYSIS 1128-347 TRANSLINK 1384-257-01
-
$375.00
INDUSTRIAL EQUIPMENT BOARD BAROC ECU-PCLe H-LINK E345219 MODEL136
-
$890.00
RESEARCH CONCEPTS RC 2000 DUAL AXIS ANTENNA CONTROLLER
The RC2000 controller family is the industry standard for dual axis antennas with pulse type position sensor.
-
$675.00
USB-6211 OEM Data Acquisition Card DAQ USB
779676-011/0 16 Input 17 Bit 250KS/s
-
$450.00
AEROTECH SERVO AMPLIFIER MODEL BA20
LISTED 11FA
MOTION CONTROL DIVISION
INPUT56-115VAC
OUTPUT 80-320VAC
-
$145.00
Sorenson Regulated DC Power Supply
Model XTS7-6
115v/60Hz 6A
-
$150.00
Panasonic Network Disk Recorder
NO Hard Drives
Model WJ-NV200K
120V
60hZ
45W
-
$1,600.00
The E 4413A diode power sensor, with wide dynamic range, is designed for use with the EPM and EPM-P series power meters for power measurements on CW signals from 50MHz to 26.6 GHz.
Features:
- Frequency Range: 50 MHz to 26.5 GHz
- Measurement range: 100 pW to 100 mW ( -70 dBm to +20 dBm)
- 50 ohm input impedance
- 3.5 mm (m) connector
- Calibration factors stored in EEPROM
- Compatible with the EPM and EPM-P series power meters
- Shipping Weight: 2 lb
-
$250.00
R32453010 Rev B BSWC 06/15
This is a Varian Agilent Signal Cable and hooks up to the Multi-Gauge & Sen Torr Gauge Controller to the Varian Glass Ion Sensor Tubes,
Cable is 10ft.
-
-
$300.00
PROFESSIONAL CRIP TOOL IN EXCELLENT CONDITION
SMA 2201301-1
-
$300.00
Professional crimp tool in excellent condition.
Model 59980-1-0
-
$300.00
AMP Professional Crimp Tool 220218-1
-
$500.00
This 7-Slot LXI chassis allows any large number of 3U PXI modules to be installed and controlled through a standardized Ethernet interface.
Each of these modules are supported as though they are an LXI compliant device, complete with a driverless soft front panel that provides complete control of the module functions.
It is the buyer’s responsibility to verify compatibility before purchase.
-
$750.00
The Michigan Scientific S-series Slip Ring Assemblies are used for a variety of applications requiring up to 10 circuit connections. They are designed to mount on the end of a rotating shaft and make electrical connection to strain gauges, thermocouples, or other sensors. The slip ring brushes and rings are made of precious metals to minimize noise and enable the assemblies to be used for low-level instrumentation signals. In addition, a high grade stainless steel case provides protection from dust and other contaminants.
-
$400.00
Viking surface mount box and Hands free Entry Phone with Enhanced Weather Protection(EWP)
Black Powder Painted Steel Finish
VE-5×5 are vandal and weather resistant as well as versatile to many viking products. The VE-Series back boxes is constructed of black powder painted steel and can be mounted to Vikings gooseneck pedestals,a single or double gang box, a wall or a post and is designed to be used with Viking flush mount products that have a 5.0 x 5.0 face plate.
Unit is new in the box.
-
$2,000.00 Original price was: $2,000.00.$1,800.00Current price is: $1,800.00.
Ladybug3 by Teledyne Flir
360 camera
no cords
-
$200.00
Vicor Corporation PRD48BH480T200B00 PRM48BH480T200B00 VI Chip PRM DC/DC,
Step Up or Down 1, Non-Isolated Outputs Evaluation Board
|
REGULATOR PRM 48V OUT 200W DEMO
|
PRM® Regulator
vicorpower.com
PRM® Regulator
PRM48BH480T200B00
S
C NRTL US
High Efficiency Remote Sense PRM Converter
FEATURES DESCRIPTION
• 45 V (38 to 55 V IN ), non-isolated ZVS buck-boost The VI Chip ® PRM ® Regulator is a high efficiency
regulator
• 5 to 55 V adjustable output range
• Building block for high efficiency DC-DC systems
• 200 W Output Power in 0.57 in 2 footprint
• 97% typical efficiency, at full load
• 1,300 W/in 3 (81 W/cm 3 ) Power Density
• Enables a 48 V to 1.5 V, 130 A isolated, regulated
solution with total footprint of 1.7 in 2 (11 cm 2 )
• Flexible “Remote Sense” architecture optimizes
regulation / feedback loop design to fit application
requirements
• Current Feedback signal allows dynamic adjustment of
current limit setpoint
• 4.93 MHrs MTBF (MIL-HDBK-217Plus Parts Count)
TYPICAL APPLICATIONS
• High Efficiency Server Processor and Memory Power
• High Density ATE system DC-DC power
• Telecom NPU and ASIC core power
• LED drivers
• High Density Power Supply DC-DC rail outputs
• Non-isolated power converters
converter, operating from a 38 to 55 Vdc input to generate
a regulated 5 to 55 Vdc output. The ZVS Buck – Boost
topology enables high switching frequency (~1 MHz)
operation with high conversion efficiency. High switching
frequency reduces the size of reactive components
enabling power density up to 1,300 W/in 3 .
The half VI Chip package is compatible with standard pick-
and-place and surface mount assembly processes with a
planar thermal interface area and superior thermal
conductivity.
In a Factorized Power Architecture™ system, the
PRM48BH480T200B00 and downstream VTM ®
transformer minimize distribution and conversion losses in
a high power solution.
An external control loop and current sensor maintain
regulation and enable flexibility both in the design of
voltage and current compensation loops to control of
output voltages and currents.
-
$450.00 Original price was: $450.00.$400.00Current price is: $400.00.
Copley Controls Stepnet Model STP-075-07
Input 20.75 volts 8 amps
Output 75 Volts, 5 cont. 7 amps
-
$70.00
Acopian Regulated Power Supply
Model RB5g500
Fuse Rating 1 A 250v