-
$350.00 Original price was: $350.00.$300.00Current price is: $300.00.
HEWLETT PACKARD ATTENUATOR 5086-7783
24VDC
70dB
-
$300.00
OPHIR PHOTONICS POWER SUPPLY NMS-NS2s-GR/9/5
POWER SUPPLY WITH CORD.
-
$75.00
HEWLETT PACKARD LO DISTRIBUTION AMPLIFIER 5086-7744
S/N 01607
GATE BIAS -1560
LO SENSE -195
3.0-6.8 GHz
5086-7744 LO DISTRIBUTION AMPLIFIER IS FOR UE IN 8561B PORTABLE SPECTRUM ANALYZER
-
$50.00
AGILENT 11713A ATTENUATOR/SWITCH DRIVER
THESE ARE THE SAME AS HP/AGILENT 73610 @ 04054
-
$1,500.00
HEWLETT PACKARD 8507A S-PARAMETER TEST SET
- Measures reflection and transmission characteristics of two-port devices in either direction with a single connection.
- Includes a frequency doubler that can be switched in to measure 3 MHz to 6 GHz in a single sweep
- Full frequency range of 300 kHz to 6 GHz is available for 8753D/E/ES and selected 8702 configurations
- Exhibits <5 dB insertion loss between the RF input and the test ports
- 15 dBm at the test port
- Includes a programmable step attenuator
-
$70.00
AGILENT E5850A Time Correlation Fixture for Oscilloscope and Logic Analyzer
The Agilent Technologies E5850A Time Correlation Fixture automates and simplifies the tedious process of setting up an oscilloscope and a logic analyzer to cross-trigger and make time-correlated measurements. It measures skew between the two instruments and configures them for cross-triggering
The Agilent E5850A is comprised of a Time Correlation Fixture and software to automate the correlation tasks. The Agilent E5850A produces mixed displays of correlated logic analysis and oscilloscope waveforms and coordinates marker moves between the Logic Analysis System and the Infiniium 548XX.
-
$375.00
NEWPORT OPTICAL POWER METER- MODEL 1830-C
- Compact, Full Featured, Benchtop Instrument
- 8 Decades of Signal Range
- Large, 4.5 Digit, Backlit, Wideview LCD
- Display Power in Watts or dBM
- Interfaces Newport Si, Ge, & InGaAs Detectors
- Optical Measurements from 190-1800nm
- Power Measurements from 100fW – 2W
- RS-232C and GPIB Built-In Interfaces
- The model 1830-c Power Meter is a high-resolution autoranging picoammeter compatible with all of Newport’s 818 Series low-power silicon, germanium and indium gallium arsenide detectors. I
-
$1,300.00
AGILENT KEYSIGHT HP OPTICAL ATTENUATOR
HIGH INPUT POWER LEVEL 2W
-
$675.00
USB-6211 OEM Data Acquisition Card DAQ USB
779676-011/0 16 Input 17 Bit 250KS/s
-
$450.00
AEROTECH SERVO AMPLIFIER MODEL BA20
LISTED 11FA
MOTION CONTROL DIVISION
INPUT56-115VAC
OUTPUT 80-320VAC
-
$145.00
Sorenson Regulated DC Power Supply
Model XTS7-6
115v/60Hz 6A
-
$1,600.00
The E 4413A diode power sensor, with wide dynamic range, is designed for use with the EPM and EPM-P series power meters for power measurements on CW signals from 50MHz to 26.6 GHz.
Features:
- Frequency Range: 50 MHz to 26.5 GHz
- Measurement range: 100 pW to 100 mW ( -70 dBm to +20 dBm)
- 50 ohm input impedance
- 3.5 mm (m) connector
- Calibration factors stored in EEPROM
- Compatible with the EPM and EPM-P series power meters
- Shipping Weight: 2 lb
-
$100.00
Mikron Infrared Thermometer with a Bushnell Phantom scope
Model m57
400- 1600 Degrees Celcius
2% accuracy
Has a Bushnell Magnum Phanton 1.3x scope
-
$100.00
Cole Parmer Pinch Valve
Pinch Valve 1/4″ x 3/8″
Max Pressure 15 PSI
13 Watts
24 VDC
-
$190.00 Original price was: $190.00.$99.00Current price is: $99.00.
HP Hewlett Packard Synthesizer Function Generator 3325A
Amplitude Calibration FAIL
-
$1,440.00
Tektronix Oscilloscope 644B. Power on self-test failure displayed in screen close up. Unit will require authorized service.
-
$9,800.00
HEWLETT PACKARD 8565E ANALYZER SPECTRUM
Tested 20 GHz but we do not have equipment to generate 50 GHz. Shown with CAL output (300Mhz). Purchaser will be responsible for calibration and/or certification.
Ser # 3432A00207
-
$2,200.00
AGILENT 8110A PATTERN GENERATER
-
$250.00
Wavelength Electronics MPT-2500
- Temperature Controller
- Temp. Range: -99 – 150?
- Temp Stability: <0.005?
- TEC Output:
- Bipolar Output Current: ±2.5A
- Maximum Output Power: 60W
- Current Limit Range: 0 – 2500mA
- Connector: 15-Pin D-Sub
- Dimensions: 3.55 x 3.5 x 1″
-
$120.00
The ADL5521 is a high performance GaAs pHEMT low noise
amplifier. It provides high gain and low noise figure for single-
downconversion IF sampling receiver architectures as well as
direct-downconversion receivers.
The ADL5521 provides a high level of integration by incorporating
the active bias and dc blocking capacitors, making it very easy
to use while not sacrificing design flexibility.
The ADL5521 is easy to tune, requiring only a few external
components. The device can support operation from 3 V to 5 V,
and the current draw can be adjusted with the external bias
resistor for applications requiring low power consumption.
The ADL5521 comes in a compact, thermally enhanced, 3 mm ×
3 mm LFCSP and operates over the temperature range of
−40°C to +85C.