Showing 1–20 of 746 results
-
Instrulab System Thermometer Model 3312A-15
$150.00Instrulab System Thermometer Model 3312A-15
the instrulab 3312a thermistor system thermometer is designed to operate in any of four modes; as a temperature monitor, as a calibrator, as a stand alone acquisition system, or as an intelligent front end for an IBM PC.
http://www.instrulab.com/files/120788617.pdf
Tested OK
No NTC thermocouple sensors
-
Loadstar Sensors DI-1000 Digital load cell interface with RSB2-01KM-S load cell
$600.00Loadstar Sensors DI-1000 Digital load cell interface with RSB2-01KM-S load cell. No manual, software, cables or other accessories. As shown.
-
Corelis 10337A High-Performance LAN & USB 2.0 Boundary-Scan Controller
$220.00Corelis 10337A High-Performance LAN & USB 2.0 Boundary-Scan Controller
-
-
-
Hewlett Packard 5086-7458 Bias Tee Assembly 26.5GHz (LOT OF 2)
$490.00Hewlett Packard 5086-7458 Bias Tee Assembly 26.5GHz (LOT OF 2)
-
HEWLETT PACKARD 5086-7781 OSCILLATOR
$790.00HEWLETT PACKARD 5086-7781 OSCILLATOR
Hp Agilent 5086-7906 (5086-6906) Yig Oscillator For 856Xe Series Spec Analyzers
-
MICROWAVE CIRCULATORS M/F (LOT OF 10)
$100.00MICROWAVE CIRCULATORS M/F (LOT OF 10)
S/N A660
DC9443
10951S-1571
-
USB-6211 OEM Data Acquisition Card DAQ USB
$675.00USB-6211 OEM Data Acquisition Card DAQ USB
779676-011/0 16 Input 17 Bit 250KS/s
-
Agilent E4413A Power Sensor, 50 MHz to 26.5 GHz, 100 pW to 100 mW, -70 dBm to +20 dBm
$1,600.00Agilent E4413A Power Sensor, 50 MHz to 26.5 GHz, 100 pW to 100 mW, -70 dBm to +20 dBm
The E 4413A diode power sensor, with wide dynamic range, is designed for use with the EPM and EPM-P series power meters for power measurements on CW signals from 50MHz to 26.6 GHz.
Features:
- Frequency Range: 50 MHz to 26.5 GHz
- Measurement range: 100 pW to 100 mW ( -70 dBm to +20 dBm)
- 50 ohm input impedance
- 3.5 mm (m) connector
- Calibration factors stored in EEPROM
- Compatible with the EPM and EPM-P series power meters
- Shipping Weight: 2 lb
-
Mikron Infrared Thermometer
$100.00Mikron Infrared Thermometer with a Bushnell Phantom scope
Model m57
400- 1600 Degrees Celcius
2% accuracy
Has a Bushnell Magnum Phanton 1.3x scope
-
-
Wavelength Electronics MPT-2500
$250.00Wavelength Electronics MPT-2500
- Temperature Controller
- Temp. Range: -99 – 150?
- Temp Stability: <0.005?
- TEC Output:
- Bipolar Output Current: ±2.5A
- Maximum Output Power: 60W
- Current Limit Range: 0 – 2500mA
- Connector: 15-Pin D-Sub
- Dimensions: 3.55 x 3.5 x 1″
- Temperature Controller
-
Tektronix 7B92A Dual Time Base Plug in Module for Oscilloscope
$60.00Tektronix model 7B92A Dual Time Base Plug in Module for Oscilloscope
-
TEKTRONIX TDS 3GV INTERFACE COMMUNICATION MODULE – NEW
Original price was: $395.00.$345.00Current price is: $345.00.TEKTRONIX TDS 3GV INTERFACE COMMUNICATION MODULE – NEW
-
External Firing Control Panel
$75.00Monitor Panel NSN 5895-01-601-3974
Item Description
External Firing control Panel.
Single Channel Circuit
A panel which is specifically designed to permit monitoring of intelligence such as that received by radio receivers, telemetric data receivers, and the like.
It may provide facilities for remotely controlling a recorder, and to signal an operator by visual and/or audible means.
FSC5895 Miscellaneous Communication Equipmentpart 4181209s/n37300147End Use (Code 21400):
Telecommunications equipmentNo MSDS. No hazardous material.No known electrostatic discharge.It is the buyers responsibility to verify compatibility before purchase.
Product has no key.
-
EUVIS AWG801 Arbitrary Waveform Generator 8 GSPS 11-bit
$3,500.00EUVIS AWG801 Arbitrary Waveform Generator 8 GSPS 11-bit
The Euvis AWG801 modules generate arbitrary CW waveforms with sampling rates up to 8 GSPS. The on-board SRAMs provide up to 8M x 11-bit data memory. The AWG modules can be controlled by a PC via a USB interface or can work alone with pre-stored waveforms. The sole RF input is a single-ended clock source CK, which can be operated up to 4 GHz with minimum power of 10 dBm. The RF outputs of the module are comprised of differential analog outputs, with 50-Ω back termination. The module accepts a high-speed trigger signal and generates three programmable marker signals. The waveform generation can be in continuous or burst/pulse mode. The waveform contents can be dynamically changed using the user page selection. Programmable profile option facilitates compound waveforms. The companion API provides an interface for software development.
Key Features
- 11-bit DAC with 10-bit linearity
- Standard AWG has sampling rate of 8 GSPS with 4 GHz external clock
- Optional 4 GHz internal clock with 10 ~ 100 MHz reference clock
- Optional sampling rate range: 4 ~ 8 GSPS with 2 ~ 4 GHz external clock
- Up to 8M x 11-bit words memory depth with multi-page configuration
- Up to 1 millisecond waveform at 8 GSPS
- Accepts external trigger and generates programmable marker signals
- Programmable cyclic length
- USB 2.0 compliant interface
- 12V power supply
- User-friendly input data formats and various built-in waveforms
- Companion API and software drivers for easy system development
- API compatible with Matlab 2010a
- API compatible with LabView
- Multi-AWG synchronization
- Aluminum anodized enclosure: 8.25 x 3.5 x 14.0 (W x H x D) inches
The flexibility of Euvis AWG modules to generate arbitrary patterns with high sample rates, dynamic page selection, and continuous or burst mode operation allow the AWG to be used for a variety of applications, such as:
- Linear Frequency Modulation (LFM) and chirping
- Frequency Modulated Continuous-wave radar (FMCW)
- Agile LO frequency synthesis
- Electronic warfare
- RF signal source generation
- Fast frequency hopping
- VSAT satellite communications
- Test and measurement equipment
-
-
Narda 8718 Radiation Monitor and Narda 8721 Probe
$425.00Narda 8718 Radiation Monitor with Narda 8721 probe included.
Untested. -
IRA S-1403 Test Set Auxiliary Accessory
$2,500.00IRA S-1403 Test Set Auxiliary Accessory
Fair Condition
Check BMI Stock for More Items
***75750***
