Showing 1–20 of 187 results
-
-
-
L.S. Starrett No. 812-12 Electronic Gage Amplifier
Original price was: $700.00.$400.00Current price is: $400.00.L.S. Starrett No. 812-12 Electronic Gage Amplifier
-
EG & G 5209 Single Phase Lock-In Amplifier 0.5 Hz – 120 kHz
$300.00EG & G 5209 Single Phase Lock-In Amplifier 0.5 Hz – 120 kHz Features: Frequency range: 0.5 Hz to 120 kHz Voltage sensitivity: 100 nV to 3 V full-scale Current input mode sensitivities: 10 fA to 300 nA full-scale 10 fA to 3 μA full-scale Line frequency rejection filter Fundamental (sine wave) or square-wave response modes Very low phase noise of < 0.005° rms. 3½-digit output readings Oscillator with variable amplitude and frequency Output time constants from 1 ms to 3 ks with 6 or 12 dB/octave roll-off Four external auxiliary ADC inputs Two external auxiliary DAC outputs Full range of auto-modes Standard GPIB (IEEE-488) and RS232 interfaces Two liquid crystal displays (LCD) and an analog panel meter for control and display of instrument outputs. No manual, cables or accessories.
-
MINI-CIRCUIT ZVE-3W-83+
$1,500.00MINI-CIRCUIT ZVE-3W-83+
COAXIAL HIGH POWER AMPLIFIER
2000-8000MHZ
High power, 3 Watt
y Wideband, 2000 to 8000 MHz
y Low noise figure, 5.8 dB typ.
y High IP3, +42 dBm typ.
y High dynamic range
y High gain, 35 dB typ. and good directivity, 35 dB typ.
y Internal voltage regulated for 13 to 18 VDC -
-
HEWLETT PACKARD 08562-60034 LOG AMPLIFIER ASSEMBLY
$70.00HEWLETT PACKARD 08562-60034 LOG AMPLIFIER ASSEMBLY
-
Hewlett Packard 5086-7519 Modulator Amplifier Detector
$2,500.00Hewlett Packard 5086-7519 Modulator Amplifier Detector
-
GENERAL MICROWAVE MODEL 1781 SP2T SWITCH
$50.00GENERAL MICROWAVE MODEL 1781 SP2T SWITCH
MICROWAVE RF PIN DIODE SWITCH RELAY
SER.9434004
-
AEROTECH SERVO AMPLIFIER BA20
$450.00AEROTECH SERVO AMPLIFIER MODEL BA20
LISTED 11FA
MOTION CONTROL DIVISION
INPUT56-115VAC
OUTPUT 80-320VAC
-
Analog Devices ADL 5521 Low Noise Amplifier
$120.00The ADL5521 is a high performance GaAs pHEMT low noise
amplifier. It provides high gain and low noise figure for single-
downconversion IF sampling receiver architectures as well as
direct-downconversion receivers.
The ADL5521 provides a high level of integration by incorporating
the active bias and dc blocking capacitors, making it very easy
to use while not sacrificing design flexibility.The ADL5521 is easy to tune, requiring only a few external
components. The device can support operation from 3 V to 5 V,
and the current draw can be adjusted with the external bias
resistor for applications requiring low power consumption.
The ADL5521 comes in a compact, thermally enhanced, 3 mm ×
3 mm LFCSP and operates over the temperature range of
−40°C to +85C.
