-
$35.00
Mean Well LRS-350-24 Power Supply
-
$35.00
Renco 388 619-2S Rotary Encoder
-
$50.00
Anritsu K110-1-R Microstrip Sliding Contact (10 Contacts to a Case)
-
-
$100.00
GIGAVAC ELECTROMECHANICAL CONTACTOR MX-12 FB
COIL 48 VDC
1433
CAGE 3CKS7
-
$250.00
LSI LOGIC DUAL CHANNEL HBA LSI22320SE
SNP030723807
DUAL CHANNEL
HIGH BANDWIDTH SERIAL PCI EXPRESS HOST INTERFACE
-
$300.00
OPHIR PHOTONICS POWER SUPPLY NMS-NS2s-GR/9/5
POWER SUPPLY WITH CORD.
-
-
$1,700.00
Cable dressing fixture 307055-2
Trimmer tool 312317-1-A
Hand tool staker and locator kit for cable dressing and trimming
-
$375.00
NEWPORT OPTICAL POWER METER- MODEL 1830-C
- Compact, Full Featured, Benchtop Instrument
- 8 Decades of Signal Range
- Large, 4.5 Digit, Backlit, Wideview LCD
- Display Power in Watts or dBM
- Interfaces Newport Si, Ge, & InGaAs Detectors
- Optical Measurements from 190-1800nm
- Power Measurements from 100fW – 2W
- RS-232C and GPIB Built-In Interfaces
- The model 1830-c Power Meter is a high-resolution autoranging picoammeter compatible with all of Newport’s 818 Series low-power silicon, germanium and indium gallium arsenide detectors. I
-
$1,300.00
AGILENT KEYSIGHT HP OPTICAL ATTENUATOR
HIGH INPUT POWER LEVEL 2W
-
-
$125.00
VIGRA VS-10 SBUS COLOR FRAME BUFFER
-
$800.00
Ultra-compact transmissive SMD microsensor
10 AMP,
75V
3 Phase Mosfet bridge with intelligent integrated Gate Drive
The module is capable of 10 amps of output current and 75 volts of DC bus voltage.
It has a full line of protection features, including undervoltage lockout protection of the bias voltage, cross conduction control and a user programmabledeaad-time control for shoot-through elimination. In addition, the bridge may be shut down by using the ENABLE control.
FEATURES:
• 75 Volt Motor Supply Voltage
• 10 Amp Output Switch Capability, All N-Channel MOSFET Output Bridge
• 100% Duty Cycle High Side Conduction Capable
• Suitable for PWM Applications from DC to 100KHz
• Shoot-Through/Cross Conduction Protection
• Undervoltage Lockout Protection
• Programmable Dead-Time Control
• Low Active Enable for Bridge Shutdown Control
• Isolated Base Plate Design for High Voltage Isolation Plus Good Thermal TransferTYPICAL APPLICATIONS
• 3 Phase Brushless DC Servo Control Fin Actuator Control Gimbal Control
• 3 Phase AC Induction Motor Control HVAC Blower Control |
|
-
$675.00
USB-6211 OEM Data Acquisition Card DAQ USB
779676-011/0 16 Input 17 Bit 250KS/s
-
$1,600.00
The E 4413A diode power sensor, with wide dynamic range, is designed for use with the EPM and EPM-P series power meters for power measurements on CW signals from 50MHz to 26.6 GHz.
Features:
- Frequency Range: 50 MHz to 26.5 GHz
- Measurement range: 100 pW to 100 mW ( -70 dBm to +20 dBm)
- 50 ohm input impedance
- 3.5 mm (m) connector
- Calibration factors stored in EEPROM
- Compatible with the EPM and EPM-P series power meters
- Shipping Weight: 2 lb
-
-
$300.00
PROFESSIONAL CRIP TOOL IN EXCELLENT CONDITION
SMA 2201301-1
-
$300.00
Professional crimp tool in excellent condition.
Model 59980-1-0
-
$500.00
This 7-Slot LXI chassis allows any large number of 3U PXI modules to be installed and controlled through a standardized Ethernet interface.
Each of these modules are supported as though they are an LXI compliant device, complete with a driverless soft front panel that provides complete control of the module functions.
It is the buyer’s responsibility to verify compatibility before purchase.